Esta sección te permite ver todos los mensajes escritos por este usuario. Ten en cuenta que sólo puedes ver los mensajes escritos en zonas a las que tienes acceso en este momento.
root@darkali:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:1e:68:3c:d1:fd
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:190 errors:0 dropped:0 overruns:0 frame:0
TX packets:190 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:14728 (14.3 KiB) TX bytes:14728 (14.3 KiB)
wlan0 Link encap:Ethernet HWaddr 00:1f:3a:7f:bf:75
inet addr:192.168.15.5 Bcast:192.168.15.255 Mask:255.255.255.0
inet6 addr: fe80::21f:3aff:fe7f:bf75/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6520 errors:0 dropped:0 overruns:0 frame:0
TX packets:6118 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4691869 (4.4 MiB) TX bytes:1021753 (997.8 KiB)
root@darkali:~#
root@darkali:~# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
default 192.168.15.1 0.0.0.0 UG 1024 0 0 wlan0
192.168.15.0 * 255.255.255.0 U 0 0 0 wlan0
root@darkali:~# echo "nameserver 192.168.15.1" >> /etc/resolv.confecho "nameserver 8.8.8.8" >> /etc/resolv.conffdisk -lfdisk /dev/sdbmkfs.ext4 /dev/sdb1dd if=/dev/zero of=/dev/sdbroot@darkali:~# lspci
00:00.0 RAM memory: NVIDIA Corporation MCP67 Memory Controller (rev a2)
00:01.0 ISA bridge: NVIDIA Corporation MCP67 ISA Bridge (rev a2)
00:01.1 SMBus: NVIDIA Corporation MCP67 SMBus (rev a2)
00:01.2 RAM memory: NVIDIA Corporation MCP67 Memory Controller (rev a2)
00:01.3 Co-processor: NVIDIA Corporation MCP67 Co-processor (rev a2)
00:02.0 USB controller: NVIDIA Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:02.1 USB controller: NVIDIA Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:04.0 USB controller: NVIDIA Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:04.1 USB controller: NVIDIA Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:07.0 Audio device: NVIDIA Corporation MCP67 High Definition Audio (rev a1)
00:08.0 PCI bridge: NVIDIA Corporation MCP67 PCI Bridge (rev a2)
00:09.0 IDE interface: NVIDIA Corporation MCP67 AHCI Controller (rev a2)
00:0a.0 Ethernet controller: NVIDIA Corporation MCP67 Ethernet (rev a2)
00:0c.0 PCI bridge: NVIDIA Corporation MCP67 PCI Express Bridge (rev a2)
00:0d.0 PCI bridge: NVIDIA Corporation MCP67 PCI Express Bridge (rev a2)
00:12.0 VGA compatible controller: NVIDIA Corporation C67 [GeForce 7000M / nForce 610M] (rev a2)
00:18.0 Host bridge: Advanced Micro Devices, Inc. [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices, Inc. [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices, Inc. [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices, Inc. [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
03:00.0 Ethernet controller: Qualcomm Atheros AR242x / AR542x Wireless Network Adapter (PCI-Express) (rev 01)
root@darkali:~#
root@darkali:~# hwinfo --help
Usage: hwinfo [OPTIONS]
Probe for hardware.
Options:
--<HARDWARE_ITEM>
This option can be given more than once. Probe for a particular
HARDWARE_ITEM. Available hardware items are:
all, arch, bios, block, bluetooth, braille, bridge, camera,
cdrom, chipcard, cpu, disk, dsl, dvb, fingerprint, floppy,
framebuffer, gfxcard, hub, ide, isapnp, isdn, joystick, keyboard,
memory, modem, monitor, mouse, netcard, network, partition,
pci, pcmcia, pcmcia-ctrl, pppoe, printer, redasd,
reallyall, scanner, scsi, smp, sound, storage-ctrl, sys, tape,
tv, uml, usb, usb-ctrl, vbe, wlan, xen, zip
--short
Show only a summary. Use this option in addition to a hardware
probing option.
--listmd
Normally hwinfo does not report RAID devices. Add this option to
see them.
--only DEVNAME
This option can be given more than once. If you add this option,
only data about devices with DEVNAME will be shown.
--save-config SPEC
Store config for a particular device below /var/lib/hardware.
SPEC can be a device name, an UDI, or 'all'. This option must be
given in addition to a hardware probing option.
--show-config UDI
Show saved config data for a particular device.
--map
If disk names have changed (e.g. after a kernel update) this
prints a list of disk name mappings. Note that you must have
used --save-config at some point before for this can work.
--debug N
Set debug level to N. The debug info is shown only in the log
file. If you specify a log file, the debug level is implicitly
set to a reasonable value.
--verbose
Increase verbosity. Only together with --map.
--log FILE
Write log info to FILE.
--dump-db N
Dump hardware data base. N is either 0 for the external data
base in /var/lib/hardware, or 1 for the internal data base.
--version
Print libhd version.
--help
Print usage.
root@darkali:~# hwinfo --cpu
01: None 00.0: 10103 CPU
[Created at cpu.455]
Unique ID: rdCR.j8NaKXDZtZ6
Hardware Class: cpu
Arch: X86-64
Vendor: "AuthenticAMD"
Model: 15.124.2 "Mobile AMD Sempron(tm) Processor 3600+"
Features: fpu,vme,de,pse,tsc,msr,pae,mce,cx8,apic,sep,mtrr,pge,mca,cmov,pat,pse36,clflush,mmx,fxsr,sse,sse2,syscall,nx,mmxext,fxsr_opt,rdtscp,lm,3dnowext,3dnow,rep_good,nopl,extd_apicid,pni,cx16,lahf_lm,extapic,cr8_legacy,3dnowprefetch,vmmcall
Clock: 2000 MHz
BogoMips: 4000.18
Cache: 256 kb
Config Status: cfg=new, avail=yes, need=no, active=unknown
root@darkali:~# hwinfo --netcard
25: PCI 0a.0: 0200 Ethernet controller
[Created at pci.328]
Unique ID: rBUF.LM0BcmBdfd4
SysFS ID: /devices/pci0000:00/0000:00:0a.0
SysFS BusID: 0000:00:0a.0
Hardware Class: network
Model: "nVidia MCP67 Ethernet"
Vendor: pci 0x10de "nVidia Corporation"
Device: pci 0x054c "MCP67 Ethernet"
SubVendor: pci 0x103c "Hewlett-Packard Company"
SubDevice: pci 0x30ea
Revision: 0xa2
Driver: "forcedeth"
Driver Modules: "forcedeth"
Device File: eth0
Memory Range: 0xf6388000-0xf6388fff (rw,non-prefetchable)
I/O Ports: 0x30f8-0x30ff (rw)
Memory Range: 0xf6389c00-0xf6389cff (rw,non-prefetchable)
Memory Range: 0xf6389800-0xf638980f (rw,non-prefetchable)
IRQ: 26 (no events)
HW Address: 00:1e:68:3c:d1:fd
Link detected: no
Module Alias: "pci:v000010DEd0000054Csv0000103Csd000030EAbc02sc00i00"
Driver Info #0:
Driver Status: forcedeth is active
Driver Activation Cmd: "modprobe forcedeth"
Config Status: cfg=new, avail=yes, need=no, active=unknown
28: PCI 300.0: 0282 WLAN controller
[Created at pci.328]
Unique ID: y9sn.9AnOduZyIOF
Parent ID: qnJ_.SBYAWohmo3A
SysFS ID: /devices/pci0000:00/0000:00:0d.0/0000:03:00.0
SysFS BusID: 0000:03:00.0
Hardware Class: network
Model: "Atheros AR242x / AR542x Wireless Network Adapter (PCI-Express)"
Vendor: pci 0x168c "Atheros Communications Inc."
Device: pci 0x001c "AR242x / AR542x Wireless Network Adapter (PCI-Express)"
SubVendor: pci 0x103c "Hewlett-Packard Company"
SubDevice: pci 0x137b
Revision: 0x01
Driver: "ath5k"
Driver Modules: "ath5k"
Device File: wlan0
Features: WLAN
Memory Range: 0xf6000000-0xf600ffff (rw,non-prefetchable)
IRQ: 19 (64431 events)
HW Address: 00:1f:3a:7f:bf:75
Link detected: yes
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v0000168Cd0000001Csv0000103Csd0000137Bbc02sc00i00"
Driver Info #0:
Driver Status: ath5k is active
Driver Activation Cmd: "modprobe ath5k"
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #27 (PCI bridge)fdisk -l #para identificar discos y particiones
dd if=/dev/sdb of=mbr_backup bs=512 count=1 #para guardar en un archivo el mbr, suponiendo que el disco aparezca como sdb
dd if=mbr_backup of=/dev/sda bs=446 count=1 #para restaurar el mbr en el HD suponiendo que te aparezca como sdaxauth generate :0 . trusted darkspark@darkspark:~/test> ./test
Cual es tu nombre:carlos
hola carlos
darkspark@darkspark:~/test> ./test
Cual es tu nombre:python -c 'print "A"*100'
hola AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
darkspark@darkspark:~/test>#!/usr/bin/perl
print "Cual es tu nombre:";
chomp($resp=<STDIN>);
$chek=`$resp`;
$respuesta=$resp;
if($chek){
$respuesta=`$resp`;
}
print "hola $respuesta\n";
exit;apt-get updateroot@darkali:~# nmap -sP 192.168.15.1/24
Starting Nmap 6.47 ( http://nmap.org ) at 2015-06-29 16:14 CDT
Nmap scan report for 192.168.15.1
Host is up (0.0028s latency).
MAC Address: 00:02:71:3F:53:43 (Zhone Technologies)
Nmap scan report for 192.168.15.5
Host is up (0.0073s latency).
MAC Address: C0:3F:D5:A7:F6:AA (Elitegroup Computer Systems Co.)
Nmap scan report for 192.168.15.6
Host is up.
Nmap done: 256 IP addresses (3 hosts up) scanned in 2.23 seconds
(192.168.15.1)crunch 6 6 abc123 | john --stdin
adb devices